Over Speed Savure.

Triggers alarms when FORKLIFT exceedS set speed

The system alerts the forklift operator / pedestrians that a preset speed has been exceeded by activating beacons or sounders as desired.

Key benefits...

• Provides warning, but does not affect the performance of the vehicle
• Fully adjustable, does not affect hydraulic lifting or travel performance
• Suitable for Gas / Diesel torque flow converter forklift trucks
• Advised for forklift truck operating areas that have pedestrian access
• Adjustable in speed
• Works in forwards and reverse
• Doesn't affect hydraulic lifting capacity of truck
• Site safety is increased
• Fuel consumption is reduced
• Over speed cornering reduced
• Forklift Tyre savings
• Engine noise level output is reduced
• Reduced insurance premiums can be made

---

Speed Savure 1 & 6

limits maximum road speed of forklift truck

Systems prevent the forklift operator exceeding a pre-settable speed limit. 

Speed Savure 1 is for Mechanical Throttle and Speed Savure 6 is for Drive(Fly)-by-wire.

A 2 speed version functional controller is now available

Key benefits...

• Limits travel speed of vehicle
• Speed Savure 1 is for Mechanical throttle
• Speed Savure 6 is for Drive(Fly)-by-wire (digitally programmable, not affected by gradient, acceleration control)
• Fully adjustable, does not affect hydraulic lifting perfomance
• Suitable for Gas / Diesel torque flow converter forklift trucks
• Advised for forklift truck operating areas that have pedestrian access
• Adjustable in speed
• Works in forwards and reverse
• Doesn't affect hydraulic lifting capacity of truck
• Site safety is increased
• Fuel consumption is reduced
• Forklift Tyre savings
• Engine noise level output is reduced
• Reduced insurance premiums can be made
• A two speed functional controller is now available (EXAMPLE - Low control = lift mast switch activated on fork elevation of 12inches and set to 5 mph and then high speed control 10 mph normal site safe speed limit (normal truck top speed =13mph) OR Low speed zone area eg 5 mph and higher speed zone area 8 mph)

---

Manual Speed Savure

manually controls forklift speed

Operator (or Foreman/Manager) can manually limit the truck speed in certain areas.

Warning devices can also be applied.

Key benefits...

• Speed can be limited by a switch, button or latching key switch
• Fully adjustable, does not affect hydraulic lifting perfomance
• Suitable for Gas / Diesel torque flow converter trucks
• Advised for forklift truck operating areas that have pedestrian access
• Adjustable in speed
• Works in forwards and reverse
• Doesn't affect hydraulic lifting capacity of truck
• Site safety is increased
• Fuel consumption is reduced
• Over speed cornering reduced
• Tyre savings
• Engine noise level output is reduced
• Reduced insurance premiums can be made

---

Zone Speed Savure

automatically controls speed in specified zones

The system prevents the operator from exceeding a pre-defined speed limit in specified zone. It can also trigger alarms if required.

This system has been shortlisted in the FLTA Awards 2010.

Key benefits...

• RFID installed on the truck
• RFID Transmitters / Receivers installed on entrances & exits
• Signals are then interfaced and produce and output signal
• Signal activates warning devices (Transmon Speed Savure (above) or the Truck EMC/VMC to control the speed)
• Suitable for any forklift truck
• Advised for forklift truck operating areas that have pedestrian access
• Site safety is increased along with all associated benefits seen on the Speed Savure range
• See other Zoning Systems